Retrotec House and Duct Simulator Manuel d'utilisateur télécharger pdf (Page 2)

Page 2 of 4

Remove the base frame from case and lay on the ground

in a rectangle as shown.

Secure the frame together using the bolts and

washers provided. Ensure brass knobs are on the

outside of the frame.

To install the legs, pair the colored dots on frame and

legs to ensure proper installation. Start by attaching

the tops of the legs to the tent frame.

You can now install the tent shell.

Note: the nylon washers

are not required here as

it is a non-moving part.

Now move to the bottom and attach as shown.

Attach the center braces to the outside edge of the leg

as shown.

● Ensure nylon washer is between frame pieces that can

move to prevent chafng.

● Make sure knobs are tight, not just snug.

Assemble frame: Step 2

Assemble frame: Step 3

Assemble Frame: Step 1

2. Attach here

1. Attach here

3. Attach here

1. Attach here

1 2 3 4

Pas de commentaire

Retrotec House and Duct Simulator Manuel d'utilisateur Page 2